RPE - Using JSON on DNG
Hi there,
I'm noticing something troubling after posting new Rational Publishing Engine templates to DOORS. I initialized the new templates, and then when I went to test them out, I received the following error message:
ID CRRRW7552E The specified artifact cannot be found in the global configuration.
Unable to load....
Error 404: Not Found
Propagated exception; original message [NotFoundException: com.ibm.rdm.internal/summaryDesignExport.json;rev=null;cs=null;uri=https://localhost.com/rm/storage/com.ibm.rdm.internal/summaryDesignExport.json]
Requirements Management/6.0.2
Has anyone seen this error message or have any suggestions for how to fix this behavior? We're using RDNG v6.0.2 iFix15.
Thanks,
David
|
Accepted answer
I appreciate for the feedback David!
We will be updating RPE Knowledge Center in the next release to ensure this information clear.
Thanks,
David Reilly selected this answer as the correct answer
Comments
David Reilly
commented Sep 21 '18, 12:08 p.m.
Thanks Fariz! Hopefully that saves anyone from going down the same path I did.
For anyone who may be in the same boat, I got out of this jam by calling a VBA macro to parse the JSON results after the document has been generated. This seems to work for the time being.
Regards,
David
|
One other answer
Should have known...
Why is this not a big bold disclaimer on the RPE help guide? Confusing.
|
Your answer
Dashboards and work items are no longer publicly available, so some links may be invalid. We now provide similar information through other means. Learn more here.
Comments
Updated main question.